Feuling Vented Dipsticks for '18-Up M8 Softail Models
- Screws into the factory oil fill spout as a stock replacement part on M-Eight Softails
- These breathing dipsticks remove unwanted build-up of blow by, which is found in engines with excessive leakdown through the rings/cylinders (a common issue with large displacement big bore engines)
- Test results show a decrease in engine sump oil levels
- Dipsticks vent/breath excessive crank case pressure from the oil tank through a breather system consisting of a oil separator system, perforated disc, replaceable filter element and umbrella flapper valve
- Choose from two venting style options when installing the dipstick
- There are two ways to read the oil level with this dipstick, with the bike on the jiffy stand (FHS) or the bike upright and level (FHU)
- If reading the dipstick with the bike on the jiffy stand you will take your reading from the dimples labeled FHS (Full Hot Stand)
- When reading the dipstick with the bike upright and level you will take the reading from the dimples labeled FHU (Full Hot Upright)
- Available in polished or fade-resistant black
- Made in the U.S.A.
NOTE: These dipsticks do get hot; use a glove when checking oil level.
NOTE: Feuling highly recommends staying off the rev limiter and running conventional oil in the M-Eight engines to help maintain ring seal and minimize blow by.
NOTE: It is important to get the correct hot oil level in your bike. Feuling recommends running the oil level 90%-99% full when hot.
NOTE: The oil pick up port is on the right side of the engine. Letting the bike idle or warm up on the kickstand will naturally fill the engine case and skew the oil level in the tank.
0710-0261 Polished
0710-0262 Black
DISCLAIMER: Not legal for sale or use in California on any pollution controlled motor vehicles.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
